330 821 6342

_____________________________________________________________

TITEN HD

HEAVY DUTY SCREW ANCHOR FOR CONCRETE & MASONRY

• Zinc Plated
• Patented, high-strength screw for concrete and masonry.
• The self-undercutting, non-expansion characteristics makes it the ideal anchor for structural applications, even at minimum edge distances & under reduced spacing conditions.
• This heat-treated anchor undercuts the concrete to create a strong mechanical interlock over the entire length of the anchor.
• Ratchet teeth on the underside of the hex-washer head help prevent the anchor from loosening in vibratory conditions.
• The head is stamped with the anchor length in inches.
• Ideal for temporary anchoring or applications where fixtures may need to be moved.

INSTALLATION

• Drill a hole in the base material using a carbide drill bit the same diameter as the nominal diameter of the anchor to be installed. Drill the hole to the specified embedment depth plus 1/2" minimum to allow the thread tapping dust to settle and blow it clean using compressed air. Overhead installations need not be blown clean. Alternatively, drill the hole deep enough to accommodate embedment depth and dust from drilling and tapping.
• Insert the anchor through the fixture and into the hole.
• Tighten the anchor into the base material until the hex washer head contacts the fixture.
• If the anchor will not install completely, remove the anchor and assure that all dust has been evacuated or drill the hole deeper. Begin re-installation of the anchor by hand to prevent cross-threading.